GetTapePosition info  Overview  Group

The GetTapePosition function retrieves the current address of the tape, in logical or absolute blocks.

DWORD GetTapePosition(

Parameters

hDevice

Identifies the device on which to get the tape position. This handle is created by using CreateFile.

dwPositionType

Specifies the type of address to obtain. This parameter can be one of the following values:

Value	Description
TAPE_ABSOLUTE_POSITION	The lpdwOffsetLow and lpdwOffsetHigh parameters receive the device-specific block address. The dwPartition parameter receives zero.
TAPE_LOGICAL_POSITION	The lpdwOffsetLow and lpdwOffsetHigh parameters receive the logical block address. The dwPartition parameter receives the logical tape partition.

lpdwPartition

Points to a variable that receives the number of the current tape partition. Partitions are numbered logically from 1 through n, where 1 is the first partition on the tape and n is the last. When a device-specific block address is retrieved, or if the device supports only one partition, this parameter receives zero.

lpdwOffsetLow

Points to a variable that receives the low-order 32 bits of the current tape position.

lpdwOffsetHigh

Points to a variable that receives the high-order 32 bits of the current tape position. This parameter can be NULL if the high-order 32 bits are not required.

Return Values

If the function succeeds, the return value is NO_ERROR.

If the function fails, the return value is one of the following error codes:

Remarks

A logical block address is relative to a partition. The first logical block address on each partition is zero.

Call the GetTapeParameters function to obtain information about the status, capabilities, and capacities of tape drives and media.

See Also

CreateFile, GetTapeParameters, SetTapePosition 

  .