You can make your own PCB adapters (for breadboarding or whatever) by designing and producing a PCB. The pads and traces must be small, so the PCB's are difficult to produce. Using a Socket may be easier, or a commercial pre-made adapter may be available. (see links below)
As an example: If you want to use 100 pin IC with 0.5 mm pitch, you will need SMD pads 0.3 mm wide and an isolation gap of 0.2 mm or 8 mil = 0.008 inch. One dot of a 300 dpi printer is 3.333 mil ; 0.00333 inch or 0.08467 mm. The 0.2 mm isolation gap or track width are only 2.36 dots of a 300 dpi printer and only 4.72 dots of a 600 dpi printer.
Laser printers may not have sufficient resolution. Try to print a line of 100 mm length in both directions and measure it with a high precision ruler. You will see errors of up to 0.5 mm and these errors are different for both directions. Using InkJet's for photo-resist is generally a better idea than laser printers - the ink on a transparency is a little more opaque than toner on a transparency generally. Some of the newer Epson Stylus inkjets are at 1440dpi, which results in higher accuracy tracks at smaller pitch
See Also:
An SMT layout for prototyping analog circuits with transistors and resistors in a premade layout. Useful for adding front end / back end signal conditioning to proto boards so I could "figure that bit out later" and just get the main part of the PCB off to production sooner. Add a terminal block for power with a couple through hole pads to route power around with jumper wires. Often, just half the circle works
+
file: /Techref/pcb/smd/adapters.htm, 2KB, , updated: 2024/4/29 10:23, local time: 2024/8/14 20:34,
3.15.239.167:LOG IN
|
©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? <A HREF="http://sxlist.com/techref/pcb/smd/adapters.htm"> SMD: Surface Mount Device Adapter PCBs</A> |
Did you find what you needed? |
Welcome to sxlist.com!sales, advertizing, & kind contributors just like you! Please don't rip/copy (here's why Copies of the site on CD are available at minimal cost. |
Welcome to sxlist.com! |
.