IREAD |
|
Description: | Read instruction at M : W into M : W |
Operation: | M : W = PROGRAM[M<<8+W] |
Flags affected: | none |
Registers affected: | M, W |
Sources referenced: | M, W |
Cycles: | 4 verified |
Opcode: | |
Details: | SX Users Manual page # 86 |
Microchip PIC syntax: | |
Notes: |
IREAD - Used to read 12-bit instruction memory. The contents of address (MODE:W) is copied into MODE:W. In other words:
After the IREAD instruction is executed, the high four bits of the addressed location are in MODE and the low eight bits are in W.
by Loren Blaney via Richard Ottosen
Also:
Contrary to some pages of the users guide and the datasheet, IREAD has been confirmed (by Guenther Daubach) to take 4 cycles in turbo mode. +
file: /Techref/scenix/inst/iread.htm, 3KB, , updated: 2008/1/21 17:11, local time: 2024/11/8 17:37,
18.226.150.136:LOG IN ©2024 PLEASE DON'T RIP! THIS SITE CLOSES OCT 28, 2024 SO LONG AND THANKS FOR ALL THE FISH!
|
©2024 These pages are served without commercial sponsorship. (No popup ads, etc...).Bandwidth abuse increases hosting cost forcing sponsorship or shutdown. This server aggressively defends against automated copying for any reason including offline viewing, duplication, etc... Please respect this requirement and DO NOT RIP THIS SITE. Questions? <A HREF="http://sxlist.com/Techref/scenix/inst/iread.htm"> SX Embedded Controller Instruction - IREAD</A> |
Did you find what you needed? |
Welcome to sxlist.com!sales, advertizing, & kind contributors just like you! Please don't rip/copy (here's why Copies of the site on CD are available at minimal cost. |
Ashley Roll has put together a really nice little unit here. Leave off the MAX232 and keep these handy for the few times you need true RS232! |
.