Sherline CNC Mill

Note, remote connect to the Chilipeppr ws: address, not wss:. E.g. ws:192.168.1.17:8989/ws. Be sure to select grbl FIRST before connecting to the port.

Todo:

• Pins to open and close collet
• Bits (0.190" diameter shaft)
• Debug e-stop / door sensor.
• Best lube?
• Hold down clamps / fixtures
• Air compressor for oil spray?
• New fan for control box?
• Better Monitor mount?

$0=10 (step pulse length, microseconds)
$1=25 (idle timeout, milliseconds)
$2=0 (step pulse invert mask, ....xyz)
$3=6 (direction invert mask, ....XYz)
$4=1 (enable invert mask, ....xyZ)
$5=0 (limit switch invert mask )
$6=0 (probe pin invert mask )
$10=1 (status report mask, position, no buffer)
$11=0.010 (junction deviation, mm)
$12=0.002 (arc tolerance, mm)
$13=1 (report in inchse, not mm)
$20=0 (soft limits disabled)
$21=1 (hard limits enabled)
$22=0 (homing disabled)
$23=0 (homing direction invert map, ...+++)
$24=25.000 (homing set speed, mm/minute)
$25=500.000 (home seek speed, mm/minute)
$26=250 (home switch debounce, milliseconds)
$27=1.000 (after home pull off, mm)
$30=1000 (max spindle speed, rpm)
$31=0 (min spindle speed, rpm)
$32=0 (laser mode, disabled)
$100=1259.843 (X steps/mm)
$101=1259.843 (Y steps/mm)
$102=1259.843 (Z steps/mm)
$110=500.000 (X max speed mm/minute)
$111=500.000 (Y max speed mm/minute)
$112=500.000 (Z max speed mm/minute)
$120=10.000 (X Acceleration, mm/sec^2)
$121=10.000 (Y Acceleration, mm/sec^2)
$122=10.000 (Z Acceleration, mm/sec^2)
$130=200.000 (X Max travel, mm)
$131=200.000 (Y Max travel, mm)
$132=200.000 (Z Max travel, mm)